Use new machine notes

1. After you buy a new machine, before you use the engine, you must first carefully read the instruction manual of the machine. You should pay special attention to the basic requirements of the book: (1) Use the specified grade of fuel, before use To fully precipitate and filter, the oiler must be kept clean. (2) The lubricating oil should be kept clean, and the quantity to be added must be sufficient, and it should be changed regularly. The use of the brand should be consistent with the regulations. (3) The air cleaner should always pay attention to maintenance. (4) Care should be taken to add cooling water, especially if the engine is not to be operated in a water shortage. (5) Always pay attention to check and tighten the relevant bolts and nuts, especially the connecting rod bolts, the bolts on the drive shaft and the lock nuts on the flywheel, and the fastening nuts on the wheels. If the user buys a new camera and really does it in accordance with the above basic requirements, then the life of the camera can be greatly extended. 2. After buying a new machine, do not carry the load operation immediately. It should be run-in according to the instructions. After the running-in is completed, the machine oil filter is cleaned and residual impurities in the engine oil are removed. If necessary, the engine oil must be replaced and the oil pan cleaned. 3, when the new machine carries on the work, should carry on strictly according to the request of the manufacturer's instructions, does not overload, does not surpass the speed, does not surpass the feed, does not have the long-term overload work. 4, can not be free to modify the new machine and any increase engine speed. In order to make the machine run faster, some users may arbitrarily adjust the fuel supply and pressure of the high-pressure oil pump, and some of them tie the governor spring wire. This is even more wrong. China Agricultural Network Editor